Lenco MC-148 DAB+ - Manual (Page 6)

5
PREPARATION FOR USE
CONNECT WITH SPEAKERS
1. Unwarp the speaker wires.
2. Place a speaker on either side of the main unit, preferably at the same
height, and with at least 150mm between each speaker and the main
unit.
3. Connect the speaker plugs to rear of the unit. Take care to match the
speaker placed to the LEFT output on the rear of the unit. Repeat for
the RIGHT speaker.
4. When connecting ensure the RED wire connects to the RED terminal
and the BLACK wire to the BLACK terminals.
CONNECT THE POWER
1. Check the voltage marked on the rear rating plate is the same as the
voltage in your area.
2. Connect the main plug to the wall socket and power on.
FITTING THE REMOTE CONTROL BATTERIES
1. Remove the battery cover (as shown).
2. Insert 2 x AAA batteries, taking note that the polarities match up.
3. Replace the battery cover, in the same manner as you removed it.
DISPOSAL OF BATTERIES
Dispose of used batteries with regard to the recycling regulations in your
area. Do not short circuit batteries or throw them into water, the general
rubbish or in a fire. Weak batteries can leak and damage the remote control.
Replace them in good time!
RIGHT SPEAKER
PEAR PANEL
ANTENNA SPEAKERS (8Ω)
LEFT SPEAKER