Lenco PA-81 - Manual (Page 4)

EN-3
against voltage surges and built-up static charges. Article 810 of the National Electrical Code.
ANSI/NFPA 65. provides Information with regard to proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of
grounding conductors, location of antenna-discharge unit, connection to
grounding electrodes. and requirements for the grounding electrode. See Figure B
LIGHTNING: For added protection for this product during a lightening storm. or when it Is left
unattended and unused for long periods of time. unplug It from the wall outlet and disconnect
the antenna or cable system. This will prevent damage to the product due to lightening and
power-line surges
POWER LINES: An outside antenna system should not be located in the vicinity of overhead
power lines or other electric light or power circuits or where it can fall into such power lines or
circuits. When Installing an outside antenna system, extreme cars should be taken to keep
from touching such power lines or Circuits as contact with them might be fatal.
OVERLOADING: Do not overload wall outlets. extension cords, or Integral convenience
receptacles as this can result in
a risk of fire or electric Shock
OBJECT AND LIQUID ENTRY: Never push objects of any kind into this product through
openings
as they may touch dangerous voltage points or short-out parts that could result in a fire or
electric
shock. Never spill liquid of any kind on the product
SERVICING: DO not attempt to service this product yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to
qualified service personnel.
DAMAGE REQUIRING SERVICE: Unplug this product from the wall outlet and refer servicing
to qualified service personnel under the following conditions
- When the power-supply cord or plug is damaged
-If liquid has been spilled. or objects have fallen into the product
-If the product has been exposed to rain or water .
-If the product does not operate normally by following the operating instructions. Adjust
only those controls that are covered by the operating instructions as an Improper
adjustment of other controls may result in damage and will often require extensive work by
a qualified technician to restore the product to its normal operation
-If the product has been dropped or damaged in any way
" When the product exhibits a distinct change in performance, this indicates a need for
service.
REPLACEMENT PARTS: When replacement parts are required. be sure the service
technician has used replacement parts specified by the manufacturer or have the same
characteristics es the original pert. Unauthorized substitutions rosy result in fire, electric shock,
or other hazards.
SAFETY CHECK: Upon completion of any service or repairs to this product, ask the service
technician to perform safety checks to determine that the product is in proper operating
condition
WALL OR CEILING MOUNTING: The product should not be mounted to a wall or ceiling
HEAT: The product should he situated away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
NOTE:
a.If the appliance with the power plug and coupler as disconnect device, disconnect device
should be easy to operate.
b.Equipment should not have been dripping or splashing up and down but also shows the
device should not be a class, such as vases filled with liquids.