Altera Arria V SoC - Manual (Page 15)

Chapter 3: Board Setup and Defaults 3–5
Factory Default Switch and Jumper Settings
June 2014 Altera Corporation Arria V SoC Development Kit
User Guide
4. Set the following jumper blocks to match Table 3–4 and Figure 3–1 .
Table 3–4. Default Jumper Settings
Board
Reference
Board Label Description
Default
Position
J3 FMCB
■ SHORT: FMCB is not in the JTAG chain
■ OPEN: FMCB is in the JTAG chain
SHORT
J6 FMC
Variable voltage:
■ 9-10: 1.2 V
■ 7-8: 1.5 V
■ 5-6: 1.8 V
■ 3-4: 2.5 V
■ 1-2: not valid
3-4: 2.5 V
J7 LMK_OSC_SEL
■ SHORT: Select to use SMA
■ OPEN: Select to use on-board VCXO
OPEN
J19 JTAG HPS SEL
■ SHORT: Controls the HPS from On-Board USB
Blaster II JTAG master.
■ OPEN: Controls the HPS from MICTOR-based
JTAG master, such as DSTREAM or Lauterbach
programming cables. Also, sets SW4.1 to ON to
remove the On-Board USB Blaster II from
driving the HPS JTAG input port in this mode.
SHORT
J21 JTAG SEL
■ SHORT: The USB Blaster II is the source of the
JTAG chain.
■ OPEN: The Mictor is the source of the JTAG
chain.
SHORT
J28 JTAG MIC SEL
■ SHORT: JTAG TRST input to HPS driven from
the JTAG chain.
■ OPEN: JTAG TRST input to HPS driven from the
MICTOR.
OPEN
J37 CLKSEL0 Selects the HPS clock settings. ( 1 )
SHORT pins
2-3
J38 CLKSEL1 Selects the HPS clock settings. ( 1 )
SHORT pins
2-3
J39 BOOTSEL0 Selects the boot mode and source for the HPS. ( 1 )
SHORT pins
1-2
J40 BOOTSEL1 Selects the boot mode and source for the HPS. ( 1 )
SHORT pins
2-3
J41 BOOTSEL2 Selects the boot mode and source for the HPS. ( 1 )
SHORT pins
1-2