Release information, Installation and licensing – Altera Interlaken MegaCore Function User Manual
Page 10

1–4
Chapter 1: About This MegaCore Function
Release Information
Interlaken MegaCore Function
June 2012
Altera Corporation
User Guide
For all Interlaken MegaCore function variations that target a Stratix IV GX device,
Altera recommends that you target a C2 speed grade device. For all variations that
target a Stratix IV GT device, Altera recommends you target an I1 speed grade device.
In all cases, Altera recommends that you set the Optimization Technique in the
Analysis & Synthesis Settings dialog box to Speed.
f
For information about how to apply the Speed setting, refe
of the
Quartus II Handbook.
Release Information
provide information about this release of the Interlaken
MegaCore function.
lists the release information common to all Interlaken
MegaCore function licenses.
lists the license information for this release of the Interlaken MegaCore
function.
Altera verifies that the current version of the Quartus II software compiles the
previous version of each MegaCore function. Any exceptions to this verification are
reported in the
compilation with MegaCore function versions older than the previous release.
Installation and Licensing
The Interlaken MegaCore function is part of the MegaCore IP Library, which is
distributed with the Quartus II software and downloadable from the Altera website,
Table 1–5. Interlaken MegaCore Function Release Information
Item
Value
Version
12.0
Release Date
June 2012
Vendor ID
6AF7
License Ordering Codes and Product IDs are listed in
Table 1–6. Interlaken MegaCore Function License Ordering Codes and Product IDs
License
Ordering Code
Product ID
20G License
IP-INTLKN/20G/4L
00DA
40G License
IP-INTLKN/40G/8L
00D5
100G Licenses
IP-INTLKN/100G/20L
00D6
IP-INTLKN/100G/12L
00D4
Note to
:
(1) For information about the different licenses, refer to