Altera Nios II - Manual (Page 10)

10 Altera Corporation
Nios II Evaluation Kit User Guide October 2005
Using the Nios II Evaluation Kit
Figure 1. Detailed View of the Nios II Evaluation Board
Setting Up the Nios II Evaluation Board
To set up the Nios II evaluation board, follow these steps:
1. Remove the Nios II evaluation board from its anti-static shipping
bag. Take care not to expose the board to electrostatic discharge
(ESD) during setup or use.
2. Place the board legs-down on a flat surface.
3. Connect the USB cable between the board and your PC. Your PC
will detect new hardware.
USB Connector
RJ-45 Ethernet Connector
EP1C12F324 FPGA
8-MB Flash Memory Prototyping Area
Prototyping Header
Speaker Connector
10/100 Ethernet PHY Device
EPCS4 Serial
Configuration Device
User-Defined Switches
16-MB SDRAM
User-Defined LEDs