Altera RapidIO MegaCore Function - Manual (Page 196)

Info–4 Additional Information
Document Revision History
RapidIO MegaCore Function August 2014 Altera Corporation
User Guide
July 2010 10.0
■ Added preliminary support for Cyclone IV GX devices.
■ Added support for configurable number of link-request attempts to be sent before fatal
error, after time-out on link-response.
■ Added support for order preservation between read and write requests that come in on the
Avalon-MM interface.
■ Removed support for Stratix GX devices.
November 2009 9.1
■ Added preliminary support for Cyclone III LS and HardCopy IV GX devices.
■ Added support for 5.0 Gbaud data rate.
■ Added support for order preservation between I/O write requests and DOORBELL requests.
■ Added NWRITE_R completion indication.
■ Added post-reset ackID synchronization.
■ Added transceiver configuration using full transceiver parameter editor.
March 2009 9.0
■ Corrected to preliminary support for HardCopy II devices.
■ Clarified the RapidIO IP core uses the transceiver bonded mode where relevant.
■ Updated Table 4–17.
February 2009 9.0
■ Added preliminary support for Arria II GX devices.
■ Added preliminary support for HardCopy III and HardCopy IV E devices.
■ Added support for outgoing multicast-event symbol generation.
■ Added support for 16-bit device ID.
■ Added Appendix C, Porting a RapidIO Design from the Previous Version of the Software.
November 2008 8.1
■ Added full support for Stratix III devices.
■ Added support for incoming multicast transactions.
■ Added GUI and register support to enable or disable destination ID checking.
■ Added GUI support to set transceiver starting channel number.
■ Added requirement to configure a dynamic reconfiguration block with Stratix IV
transceivers, to enable offset cancellation.
■ Updated Figure 4–6 and Figure 7–2.
May 2008 8.0
■ Added Arria GX device support for 1x mode 3.125 GBaud variation.
■ Added Stratix IV device support.
■ Added GUI support to set VCCH and reference clock frequency.
■ Simplified Physical layer description in Functional Description chapter.
■ Updated the performance information.
October 2007 7.2
■ Added Avalon-ST pass-through interface to SOPC Builder flow.
■ Added support for EDA page and an option that creates a netlist for use by third-party
synthesis tools.
■ Reorganized the user guide to make finding information easier and more efficient.
Date Version Changes