Oldsmobile 2001 Aurora - Manual (Page 90)

2-20
To program the new key:
1. Insert the current driver’s key (black in color) in the
ignition and start the engine. If the engine will not
start, see your dealer for service.
2. After the engine has started, turn the key to LOCK,
and remove the key.
3. Insert the key to be programmed and turn it to RUN
within 10 seconds of removing the previous key.
4. The SECURITY telltale light will turn off once the
key has been programmed. It may not be apparent
that the SECURITY light went on due to how
quickly the key is programmed.
5. Repeat Steps 1 through 4 if additional keys are
to be programmed.
If you are ever driving and the SECURITY light comes on
and stays on, you will be able to restart your engine if you
turn it off. Your PASS
- Key III system, however, is not
working properly and must be serviced by your dealer.
Your vehicle is not protected by the PASS
- Key III system
at this time.
If you lose or damage a PASS - Key III key, see your
dealer or a locksmith who can service PASS - Key III to
have a new key made.
New Vehicle “Break - In”
NOTICE:
Your vehicle doesn’t need an elaborate “break - in.”
But it will perform better in the long run if you
follow these guidelines:
D Don’t drive at any one speed
-- fast or
slow -- for the first 500 miles (805 km).
Don’t make full - throttle starts.
D Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking
- in guideline every
time you get new brake linings.
D Don’t tow a trailer during break - in.
See “Towing a Trailer” in the Index for
more information.