Subaru 2009 Impreza - Manual (Page 192)

! Category selection
When in the SAT mode, press the “CAT”
button “ ” or “ ” to change to the
category search mode.
When in the category search mode,
pressing the
“CAT” button “ ” changes
the category up by one step. Pressing “ ”
changes the category down by one step.
When a category is selected, turning the
“CH” dial selects channels only within the
selected category.
The control function returns to the normal
mode after approximately 10 seconds.
! Channel scan
Press the “SCAN” button to change the
radio to the SCAN mode. In this mode,
under the selected category, the radio
scans through the channel until a station
is found. The radio will stop at the station
for 5 seconds while displaying the channel
number, after which scanning will continue
until the entire channel has been scanned
from the low end to the high end.
Press the
“SCAN” button again to cancel
the SCAN mode and to stop on any
displayed channel.
& Channel preset
! How to preset channels
1. Press the
“SAT” button to select SAT1,
SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for
more than 1.5 seconds to store the
channel. If the button is pressed for less
than 1.5 seconds, the preceding selection
will remain in memory.
NOTE
If the connection between the radio and
battery is broken for any reason such
as vehicle maintenance or radio re-
moval, all channels stored in the preset
buttons are cleared. If this occurs, it is
necessary to reset the preset buttons.
Audio
5-15
– CONTINUED –