Subaru 2009 Impreza - Manual (Page 364)

Wattage Bulb No.
1) High beam headlight 12V-60W 9005 (HB3)
2) Low beam headlight (except WRX STI)
Low beam headlight (WRX STI) 12V-55W
12V-35W H11
D2S
3) Front turn signal/Front side marker light 12V-27/8W 1157NA
4) Map light 12V-8W –
5) Dome light 12V-8W –
6) Front fog light 12V-51W 9006 (HB4)
7) Trunk room light (4-door) 12V-5W (W5W)
8) High mount stop light (4-door, if equipped) 12V-21W (P21W)
9) Rear turn signal light (4-door) 12V-21W (WY21W)
10) Back-up light (4-door) 12V-16W 921
11) Brake/tail and rear side marker light (4-door) 12V-21/5W 7443
(W21/5W)
12) Cargo area light (5-door) 12V-5W –
13) Rear side marker light (5-door) 12V-5W 168
14) Rear turn signal light (5-door) 12V-21W (WY21W)
15) Back-up light (5-door) 12V-21W 7440
16) Licence plate light 12V-5W 168 (W5W)
A) High mount stop light (5-door) – –
B) Brake/tail light (5-door) – –
C) High mount stop light (4-door, if equipped) – –
CAUTION
Replace any bulb only with a new
bulb of the specified wattage. Using
a bulb of different wattage could
result in a fire.
& Headlights (WRX STI)
WARNING
High-intensity-discharge (HID) bulbs
are used for the low beams of the
headlights. These HID bulbs use an
extremely high voltage. To avoid the
risk of an electric shock and result-
ing serious injury, you should not
attempt to replace them. Neither
should you attempt to replace the
high-beam bulbs, remove/refit the
headlight assemblies, or remove
any headlight-assembly compo-
nents. For replacement of the head-
light bulbs (low-beam and high-
beam), removal and installation of
the headlight assemblies, and re-
moval of headlight-assembly com-
ponents, contact your SUBARU
dealer.
Maintenance and service
11-49
– CONTINUED –