Denon DHT-M330DV - Manual (Page 30)

30
ENGLISH
1 5
3
5
2
3
1
(2) Input mode setting
1 Press the FUNCTION button to select the input function to be
played.
• The function switches as shown below.
• The function only changes in the “Æ” direction when
operated from the remote control unit.
• Factory default (TAPE) = TAPE
DVD TUNER TV/AUX1 AUX2 (TAPE)
Main unit Remote control unit
2 When DVD, TV/AUX1, AUX2 was selected as the input
function, press the remote control unit’s INPUT MODE button
to select the input mode.
• Consider “AUTO” as standard position.
• “ANALOG” cannot be selected when TV/AUX1 or AUX2
was selected as the input function.
• “ANALOG” can be selected when “TAPE” is set to
“TV/AUX1” at “FUNCTION SETUP” under “QUICK
SETUP” in the detailed settings.
AUTO PCM DTS ANALOG
Remote control unit
Input mode selection function
• The input mode can be selected when the input function is
set to DVD, TV/AUX1, AUX2.
• Different input modes can be selected for each input
function. The selected input mode is stored in the memory
for the individual input functions.
• When the input function is set to something other than the
above, “ANALOG ONLY” is displayed and the input mode
cannot be selected.
q AUTO (auto mode)
In this mode, the type of signal being input to the digital
and analog input terminals is detected and the program in
the set’s surround decoder is switched automatically to
play the signals for the selected input function.
The presence or absence of digital signals is detected, the
signals input to the digital input are identified and decoding
and playback are performed automatically in DTS, Dolby
Digital or PCM (2 channel stereo) format.
If no digital signal DVD is being input, the analog input
jacks are selected.
Use this mode to play Dolby Digital signals.
w PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM
signals are being input.
e DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS
signals are being input.
r ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are played.
(This cannot be selected in the TV/AUX1, AUX2 mode.)
The input mode automatically switches to “AUTO” if you
switch the input function to DVD from anything other than
DVD.
3 Press the SURROUND button to select the surround mode.
Main unit Remote control unit
• The function switches as shown below.
AUTO DECODE 5CH STEREO HALL
STEREO DIRECT AUTO DECODE
DOLBY VS