Applied Motion PDO2035 - Manual (Page 5)

Connecting the AC Line
110 Volts
220 Volts
The PDO 2035 is set for 110 volt operation at the factory. In order to use 220 volts,
you'll need to remove the cover and slide the switch to the "220V" setting.
First, disconnect all power from the system. Next, remove all four of the
green connector plugs from the front panel. Then, using your small Phillips screw
driver, remove the five screws that hold the cover on.
The cover will slide off easily once all of the screws are removed. You should see a
black switch near the "AC POWER" connector, right next to the big transformer.
Push the switch to the "220V" side.
Now put the cover back on and replace all five screws, tightening them carefully.
Never operate the drive with the cover off
-12- -5-
.125
AMPS/PHASE
Current Setting Table
2345
1000
500
250
125
1.125
AMPS/PHASE
.25
AMPS/PHASE
1.25
AMPS/PHASE
.375
AMPS/PHASE
1.375
AMPS/PHASE
.5
AMPS/PHASE
1.5
AMPS/PHASE
.625
AMPS/PHASE
1.625
AMPS/PHASE
.75
AMPS/PHASE
1.75
AMPS/PHASE
.875
AMPS/PHASE
1.875
AMPS/PHASE
1
AMPS/PHASE
2
AMPS/PHASE
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
2345
1000
500
250
125
!
The PDO 2035 is set for 110 volt operation at the factory. All you need to do is
install a power cord and plug it in. If you want to direct wire the PDO 2035 to AC
power, you must consult a qualified electrician and observe all building and
electrical codes.
You can install the AC cord yourself, but be careful: AC power can be dangerous.
k c a l b
e ti h w
n e e r g
To Earth Ground
To Neutral
To Line (Hot)
To Earth Ground
To Neutral
To Line (Hot)
green
blac
k or brown
whit
e or blue
"Old Style" AC Power Plug "New Style" AC Power Plug
Installing an AC Line Cord
Remove about 5 mm (3/16 inches) of insulation from each of the three wires of your
line cord. (That's right, three wires. For safety, always use a three wire power cord
on anything with a metal case.) Depending on where you got your power cord, it
may have black, white and green wires or brown/blue/green.
The AC power plug that was shipped with your PDO 2035 might be one of two
types. The "old style" is shown below, on the left. The "new style" (shown on the
right) comes with an insulating rubber boot.
Make sure you follow the proper
sketch for your connector style.