SoundMax SM-CDM1053 - Manual (Page 13)

13
Radio operations
BAND selection
Press repeatedly BAND button to select your desired radio band in radio mode: FM1, FM2, FM3, FM (OIRT),
AM1 (MW1), AM2 (MW2). Each band can store 6 preset stations, for a total of 36 preset memory stations.
Tuning
Press PREVIOUS or NEXT button to manually adjust the radio frequency. Press and hold PREVIOUS/NEXT
buttons, the radio will seek to the next up or down strong and clear frequency station automatically. Repeat
this action to seek for other desired stations. To stop automatic search, press NEXT or PREVIOUS button.
Automatic seek/preset scan
Preset scan: Press A/PS button once to automatically search for saved stations in each band.
Automatic store: Press and hold A/PS button, the receiver will automatically scan and save stations for
the current band. As soon as automatic store is performed, the unit will start preset scanning.
Radio scan
Press SCN button. The unit will scan all saved stations in each band holding 5 seconds on each station.
Programming stations
There are 6 numbered preset buttons, under which you can store and recall stations for each band. Select the
needed station, then press and hold a preset button. The station will be saved in the memory under the
corresponding number. To recall a stored station, press the corresponding preset button.
Local/distant reception
Press and hold SELECT button, then press it repeatedly to select DX (LOCAL). If LOCAL is displayed, it means
that local station reception is activated. DX means that distant stations with both strong and weak signal are
received. Switch between LOCAL and DX by rotating VOL knob.
Mono/stereo reception (for FM radio)
Press and hold SELECT button, then press it repeatedly to select STEREO reception or MONO reception for FM
bands. Mono receptions enables achieve a better signal quality due to noise reduction. Switch between MONO