Rear panel connections, Overview, Power – CUE smartCUE User Manual
Page 22: Cuering, Microphone input, Line inputs, Line outputs, See chapter power supply, See chapter system connection by cuering
User Manual Interfaces
www.cuesystem.com
Page 22 of 44
6.2. Rear Panel Connections..............................................
6.2.1. Overview
All connectors are located on the rear panel - see picture below.
GND
DATA OUT
DATA IN
A
4
3
2
1
D
C
B
INPUTS
OUTPUTS
DC IN
24V
Power Supply
24 VDC
Microphone
Input
Line Outputs
1 to 4
Line Inputs
1 to 4
CUEring
Output
CUEring
Input
Ground
MIC
6.2.2. Power
See chapter Power Supply.
6.2.3. CUEring
See chapter System Connection by CUEring.
6.2.4. Microphone Input
The input marked MIC is a standard microphone input including power supply for electret condenser
microphones. It uses jack 6.3 mm connector
6.2.5. Line Inputs
Inputs marked INPUT A to D are standard stereo line unbalanced audio inputs which use standard
1/4" RCA jack connectors.
6.2.6. Line Outputs
All outputs marked OUTPUT 1 to 4 are stereo line unbalanced audio outputs which use standard 1/4"
RCA jack connectors.