d&b Z5010 TV spigot with fixing plate - Manual (Page 3)

(2.0 E) 3-8
WARNING!
WARNING!
General Safety and Installation Advice
General safety advice
d&b loudspeakers should only ever be flown or installed using
recommended d&b rigging accessories. The d&b rigging accessories
described in the d&b rigging accessories manual and the specific
mounting instructions are designed and manufactured to have a
high load safety factor for their intended role. In order to ensure
the highest safety standards, the information presented here on the
assembly and safe use of d&b rigging accessories must be carefully
understood and followed.
The installation of d&b loudspeakers using the rigging accessories
described in the d&b rigging accessories manual and the specific
mounting instructions should only ever be carried out by properly
qualified personnel in full compliance with all required safety codes
and safety standards in force at the place of installation.
(In Germany, this means compliance with the recommendations of
BGV C1 (GUV 6.15))
d&b rigging accessories (components and assemblies) are supplied
exclusively for use with specific d&b loudspeakers and are not
designed or intended for use with any other loudspeakers or any
other devices. The use of d&b rigging accessories to deploy
loudspeakers and devices other than those indicated in the d&b
rigging accessories manual and the specific mounting instructions is
improper use. Improper use can compromise safety by overloading
and damaging the rigging accessories. d&b will not be held
responsible for any damage or injury resulting directly or indirectly
from the improper use of d&b rigging accessories.
d&b rigging accessories must not be modified in any way nor should
they be assembled in ways other than those indicated in the d&b
rigging accessories manual and the specific mounting instructions.
Rigging components supplied as part of a complete assembly are
non-interchangeable and must not be exchanged with the
component parts of any other assembly.
The component parts of a d&b rigging accessory must only be
assembled using the fasteners and methods of assembly
recommended in the d&b rigging accessories manual and the
specific mounting instructions. The use of fasteners and methods of
assembly not specified or approved by d&b may result in an unsafe
rigging assembly. Welding, or any other means of permanently
fixing rigging components to each other or to cabinet fixing points is
not allowed.
General installation advice
Only the screws, fasteners, plain and shakeproof washers specified
on the relevant page(s) of the d&b rigging accessories manual and
the specific mounting instructions shall be used to fasten together,
where appropriate, suitable d&b rigging components.
d&b rigging components or assemblies must only be fixed to d&b
loudspeaker cabinets using the cabinet fixing points, assembly
methods and fasteners specified on the relevant page(s) of the d&b
rigging accessories manual and the specific mounting instructions.