d&b Z5010 TV spigot with fixing plate - Manual (Page 8)

(4.0E) Z5010 (Version 2)
WARNING!
WARNING!
Z 5010,
TV spigot with fixing plate
[1]
[2a]/
[2b]
[3]
[4]
Z5010 TV spigot with fixing plate (Version 2)
The Z5010 TV spigot with fixing plate allows certain d&b
loudspeakers to be attached to the telescopic lighting supports
normally used in broadcast studios. Used with a Z5012 Pipe clamp
(SWLmax 50 kg/110 lb) it also allows certain d&b loudspeakers to
be suspended from an overhead bar or truss with a tube diameter
between 32 mm and 50 mm.
The TV spigot fixing plate is normally bolted directly to the M8
threaded inserts of E1 or E3 cabinets using the screws and washers
provided but may also be used with other d&b loudspeaker rigging
accessories.
− Direct assembly to E1 or E3 loudspeakers
− Direct assembly to 2 x E3 using Z5031 E3 Standard bracket
− Z5023 02 Flying bracket
− Z0124 E1 Vertical bracket
− Z0126 E1 Horizontal bracket
− Z5032 E3 Swivel bracket
− Z5028 E3 Horizontal bracket
− Z5030 E3 x 2 Angle bracket
− Z5052 CI6/CI9 Flying bracket
Safety instructions
Secondary safeties should always be provided and
used when flying or fixing loudspeaker loads
overhead.
Load safety informations
The maximum permitted safe working load (SWL) for
the Z5010 TV spigot with fixing plate is 50 kg/110 lb
and this value must on no account ever be exceeded.
Additionally, the load force must only act vertically on
the fixing plate - any type of shear load must be
avoided.
Part list Z5010
− 1 x Z5010, TV spigot with fixing plate [1]
− 2 x DIN 933-M8x18-8.8 Hex head bolt [2a]
− 2 x DIN 933-M8x25-8.8 Hex head bolt [2b]
− 2 x 8.2 Spring washer [3]
− 2 x 8.4 Plain washer [4]
Weight Z5010
0.87 kg/1.91 lb