d&b Z5399 YiP Mouting bracket - Manual (Page 4)

1.1. Scope of supply and weight
Please verify the shipment for completeness and proper condition
of the items.
Qty. d&b Code Description
1 Z5399 YP Mounting bracket consisting of:
–
Outer bracket [A]
– Inner bracket [I]
Including:
2 Hand bolts [H]
1 D2819.EN .01 Z5399 Mounting instructions
Weight 2.4 kg (5.3 lb)
1.2. Safety precautions
General safety
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure
that the suspension/fixing points are suitable for the intended use.
Always carry out a visual and functional inspection of the items
before use. In case there is any doubt as to the proper functioning
and safety of the items, these must be withdrawn from use
immediately.
Load safety information
The Z5399 YP Mounting bracket is designed to support one YiP
loudspeaker (Yi7P or Yi10P).
No additional loads must be added.
The bracket must only be used in an upright position or suspended
vertically as shown in the graphic opposite.
1.3. Intended use
The d&b Z5399 YP Mounting bracket must only be used in
conjunction with d&b YP or YiP cabinets.
The tie bar of the outer bracket is supplied with two M8 threaded
inserts at the standard d&b spacing (115 mm [4.5"]) for attaching
the following accessories:
1. Z5399 YP Mounting bracket
d&b Z5399 Mounting instructions 1.1 en 4