d&b Z5399 YiP Mouting bracket - Manual (Page 5)

– Using the Z5010 TV spigot with fixing plate in conjunction
with the Z5012 Pipe clamp, YiP cabinets can be vertically
flown from overhead bars or trusses with a tube diameter
between 40 mm and 70 mm (1.5" and 2.75").
– Using the Z5024 Loudspeaker stand adapter, YiP cabinets
can be mounted onto a loudspeaker stand with a tube
diameter of 35 mm/1.4".
The two M10 threaded inserts at the edges of the tie bar are
intended for use with two M10 safety eye bolts (Q9032) to
suspend the cabinet using steel wire ropes. They also serve to
"park" the two hand bolts [H] during storage or transport when the
bracket is not mounted to a cabinet so that the hand bolts cannot
get lost.
1.4. Assembly
The fixing plate of the inner bracket
[I] is bolted into the M10
threaded inserts at the top or bottom of the loudspeaker cabinet
using the two hand bolts [H].
Mounting options
The bracket can be attached in three ways (Type A, B, C).
However, for flown applications we recommend to attach the
bracket according to type A. This allows the efficient attachment of
a secondary safety device.
1.5. Adjustments
The vertical aiming and the horizontal aiming can be set
continuously.
Vertical aiming
1. Slightly slacken the fixing screws
[F].
2. Set the loudspeaker to the required vertical angle.
3. Retighten the fixing Screws
[F].
Horizontal aiming
The horizontal aiming is set at the loudspeaker stand adapter or
the TV spigot assembly.
d&b Z5399 Mounting instructions 1.1 en 5