Dacor EH36 - Manual (Page 13)

11
Tip the hood back down so that the top of the hood 17.
faces up. Using existing screws, attach the cover plate
removed in step 3 to the top of the hood to cover the
hole.
Attach the duct collar removed in step 2 to the back of
18.
the unit using four (4) existing screws.
Rotating the Blower for Models:
eh4812 and Mh4812 (Models that are 12
inches high equipped with two blowers.
Place the hood assembly on a large flat surface.1. 1.
Remove and save the screws and the two (2) duct col- 2.
lars from the top of the unit. See below.
Remove and save the screws and the two (2) cover
3.
plates that cover the holes on the back of the hood.
Insert the opening on the blower motor assembly into 13.
the hole inside the back of the hood. The connector
on the motor must be toward the bottom of the hood.
Attach it using four (4) nuts.
Route the wiring harness as shown. Secure the har- 14.
ness to the motor assembly with the cable clamps sup-
plied with the hood in the positions shown below.
Attach the wiring harness to the brace inside the hood,
15.
on the right side using two (2) supplied cable ties.
Use a cable tie to take up any remaining slack that may
16.
exist in the wiring harness. Stow the harness behind
the plate on the right side. Securing any slack will
reduce additional noise due to vibration.
Installation Instructions
Connector
location
Cover Plate
Duct Collar
Cable
Clamps Wiring
Harness
Cable
Ties
Cable tie if
necessary
iMportAnt: For proper
operation, route and secure
the harness exactly as shown.