Dacor EH36 - Manual (Page 16)

14
Installation Instructions
Disconnect the wiring harness connector from the 8.
blower motor.
While supporting the blower from below, remove the
9.
four (4) nuts that hold the blower in place. Remove the
blower from the hood.
Insert the opening on the blower motor into the hole 10.
inside the back of the hood. The connector on the
motor must be toward the bottom of the hood. Attach it
using four (4) nuts.
Route the wiring harness as shown. Secure the har- 11.
ness to the motor assembly with the cable clamps sup-
plied with the hood in the positions shown below.
Attach the wiring harness to the brace inside the hood
12.
on the right side using two (2) supplied cable ties.
Use a cable tie to take up any remaining slack that may
13.
exist in the wiring harness. Stow the harness behind
the plate on the right side. Securing any slack will
reduce additional noise due to vibration.
Tip the hood back down so that the top of the hood 14.
faces up. Using four (4) existing screws, attach the
cover plate removed in step 3 to the top of the hood to
cover the hole.
Attach the duct collar removed in step 2 to the back of
15.
the unit using the four (4) existing screws.
Connector
location
Cable
Clamps
Wiring
Harness
Cable
Ties
Cable tie if
necessary
iMportAnt: For proper
operation, route and secure
the harness exactly as shown.