Desa CDCFTP - Manual (Page 29)

www.desatech.com 111244-01D 29
Clean the pilot assembly also. A yellow tip on the
pilot flame indicates dust and dirt in the pilot as-
sembly. There is a small pilot air inlet hole about
two inches from where the pilot flame comes out
of the pilot assembly (see Figures 56 or 57 depend-
ing on model). With the unit off, lightly blow air
through the air inlet hole. You may blow through a
drinking straw if compressed air is not available.
CLEANING AND
MAINTENANCE
Continued
Figure 56 - Pilot Inlet Air Hole
(Propane/LP Gas)
Pilot Assembly
Pilot Air Inlet Hole
Pilot Assembly
Pilot Air
Inlet Hole
Figure 57 - Pilot Inlet Air Hole
(Natural Gas)
WIRING DIAGRAM
(Remote-Ready Models Only)
Switch
Black
Auto
Of
f
On
Red Red
White
Thermopile
Gas Control
TPTH
TH
TPTH
TP
LOG SET
• If you remove one-piece log set for cleaning,
refer to page 21, for placement instructions.
• Replace log set if broken or chipped (dime-sized
or larger).
CABINET
Air Passageways
• Use a vacuum cleaner or pressurized air to
clean.
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture. Wipe the cabinet to re-
move dust.