Future Automation CH - Manual (Page 15)

  SLQV
In
st
all
at
io
n
: E
le
ctr
ic
al
C
on
ne
cti
on
Page 14 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
CH - Ceiling Hinge
CH Contact Closure
- Use an RJ45 connector in the CCI
socket on the control box to operate
via contact closure
LED 1
LED 2
LED 3
LED 4
LED 5
CONTACT CLOSURE INPUT
NOTE:
Earlier versions of the control board
may not have these contact closure
LED indicators.
568A 568B
1 12V SUPPLY 12V SUPPLY - CURRENT LIMITED W/G W/O
2 12V LATCH
When 12V attached, device will go OUT to 90 degrees. When
12V removed, device will go IN.
G O
3 GROUND GROUND W/O W/G
4 PIN 4 NOT USED BL BL
5 DEVICE LATCH
Short to GROUND (pin 3), device will go OUT to 90 degrees.
When short removed, device will go IN.
W/BL W/BL LED 4
6 DEVICE STOP
Momentary short to GROUND (pin 3), stops device in current
position.
O G LED 3
7 DEVICE HOME
Momentary short to GROUND (pin 3), makes device go OUT
to 100 degrees.
W/BR W/BR LED 2
8 DEVICE IN Momentary short to GROUND (pin 3), makes device go IN. BR BR LED 1
PIN DESCRIPTION ACTION
WIRE / CABLE CONTACT CLOSURE
LED INDICATOR