Future Automation CH - Manual (Page 6)

In
st
al
la
ti
o
n
:
S
ta
ge
1
Page 5 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
CH - Ceiling Hinge
- THE BOX MUST BE EASY TO ACCESS!
- Connect the control box to the DC power supply and the
PSU to the mains
- Connect the infrared remote sensor even if you are going
to use switch control
- See operations page
Control box setup
Before you start, check the following:
-The product is in good condition
-No damage to any parts
-Wiring is all secure
-The unit is in the closed position
-Test the mechanism by running it up and down, best done with it upside down on the floor
-See page 13-16 for controls.
HOME - Takes hinge to a
position of 100 degrees
OUT - Takes hinge to a
position of 90 degrees
IN - Takes hinge all the
way up to being flush with
ceiling