ILUMINARC Colorist™ Line 12Qa - Manual (Page 5)

Colorist™ Line 12Qa QRG EN
5
DMX Linking The Colorist™ Line 12Qa will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.iluminarc.com .
DMX Connection The Colorist™ Line 12Qa uses a regular DMX data connection for its
DMX personalities: 4-CH, 6-CH, 10CH, 48CH, and 53CH. See the User
Manual to connect and configure for DMX operation.
IP65 DMX Cable
Table
Connection DMX (U.S.) DMX (Europe) IP65 Pin
Ground Shield Shield 1
Data - White Blue 2
Data + Red Brown 3
IP65 DMX
Connector Pins
To connnect the Colorist™ Line 12Qa to your DMX network, it is
necessary to use the 3-pin to 5-pin adapters supplied with this
product.
When not using the Power Output, DMX Input or DMX Output
connectors, you must seal the cable ends with the supplied caps.
Control Panel
Description
Button Function
<MODE> Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently
selected value into the selected function
<UP>
Navigates upwards through the menu list or increases the
numeric value when in a function
<DOWN>
Navigates downwards through the menu list or decreases
the numeric value when in a function
Passcode After being prompted, enter the following passcode by pressing:
· <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This passcode cannot be changed and must be used whenever prompted.
F emale IP65 (DMX Output) Male IP65 (DMX Input)