ILUMINARC Ilumipanel™ 90 IP - Manual (Page 6)

Ilumipanel 90 IP Optic RGB QRG
6
Ilumicon and
DMX
Controllers
To control/operate the Ilumipanel 90 IP Optic RGB, use either an Ilumicon
or a DMX controller. Use the standard DMX connection as shown in the
section, DMX Junction Box Wiring, to connect this product to any standard
DMX controller.
For more information, refer to the Ilumipanel 90 IP Optic RGB User
Manual.
Ilumicode
Configuration
To configure the Ilumipanel 90 IP Optic RGB, you must use the Ilumicode
addresser.
Ilumicode
Connections
The following diagram shows how to connect the Ilumicode to the product.
This connection will control multiple products at the same time. In addition,
all connected products will be assigned to the same DMX address.
To assign individual DMX addresses to each product, connect the Ilumicode
unit to each product individually. In addition, disconnect the DMX output of
the product being configured if other products are connected to it.
The Ilumicode will not work via wireless. You must hardwire the
Ilumicode directly to the Ilumipanel 90 IP Optic RGB when programming
the product.
Ilumicode
Connection
Diagram
ILUMINARC® suggests connecting no more than 20 products in this mode,
keeping the total distance to less than 60 m (197 ft). If not, you may need to
use an optically isolated signal amplifier.