ILUMINARC Ilumipanel™ 180 IP - Manual (Page 16)

Operation
12 Ilumipanel 180 IP Optic 15/30 RGB User Manual Rev. 3
4. Operation
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with the RGB
only output products.
ILUMICODE ADDRESSER
The Ilumipanel 180 IP Optic 15/30 RGB needs an external controller, the Ilumicode, to change
its configuration.
Ilumicode Panel Description
Control Options
You can set the Ilumipanel 180 IP Optic 15/30 RGB start address in the 001~512 DMX range.
This allows for the control of up to 73 products in the 7-channel ARC FULL personality.
Programming
Carry out all the programming procedures indicated below from the control panel. Refer to the
Menu Map section to learn how the menu options relate to each other.
Use <ENTER> and <MENU> to change levels in the Menu Map, moving right and left
respectively. Use <UP> and <DOWN> to move vertically within the Menu Map.
DMX Personality
1. Go to PERSON and select any DMX personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).
Button Function
<MENU> Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the
currently selected value into the selected function
<UP>
Navigates upwards through the menu list and increases
the numeric value when in a function
<DOWN>
Navigates downwards through the menu list and
decreases the numeric value when in a function
<POWER>
Turns the unit on. The unit will turn off automatically
after 30 seconds of inactivity