ILUMINARC Ilumipod™ Inground Tri-12 IP - Manual (Page 15)

Installation
Ilumipod Inground Tri-12 IP Optic WW User Manual Rev. 3 11
If you have not
configured the
DMX starting
address and
DMX mode for each
product, they will all use
their default values. This
means that all products
will operate in unison.
Caution:
W-DMX™
operation can be
interrupted or
inhibited by liquid masses
between the transmitter
and receiver such as
water, snow, or people.
For best results, please
keep the antenna clear of
any liquid mass.
Controllers
The Ilumipod Inground Tri-12 IP Optic WW can operate with a standard DMX controller or
the ILUMICODE addresser. The sections below provide information on how to connect these
products to the corresponding controllers. The instructions to operate these products with each
of the above controllers are in the
Operation section.
DMX Controller
The Ilumipod Inground Tri-12 IP Optic WW can work with a standard DMX controller. The
channel assignments will depend on the chosen personality (see the corresponding
Menu Map
section) and the DMX address assigned to each product (see the Programming section).
The figure below illustrates how to connect the DMX controller to the Ilumipod Inground
Tri-12 IP Optic WW.