KBC Networks H.264 Encoder - Manual

Introduction
Welcome to KBC Networks’ Quick Start Guide for
the H.264 encoder. This document provides
some quick tips on how to get up and running.
For more detailed information see the Downloads
section below.
Features:
• H.264 or MPEG4 selectable compression
encoding
• NTSC/PAL support
• RS-485/422, 232 support
• DI/DO bi-directional contact closure
• Compatibility with KBC MPEG4 decoder in
MPEG4 mode
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
http://www.kbcnetworks.com/ip-
encoder/network-products/ip-encoder
Specification sheet:
http://www.kbcnetworks.com/ip-
encoder/network-products/ip-encoder
IP utility:
http://www.kbcnetworks.com/specification-
downloads/software
System Contents
Qty Description
1 H.264/MPEG4 selectable encoder
1 12 Vdc 1500mA power supply
Note: The encoder is not 802.3af / at PoE compliant and
must be powered using the supplied 12Vdc
transformer
Equipment Required for Physical
Deployment
• Ethernet Cat5 or Cat6 straight-through
cable
• Coaxial cable
• Twisted pair for RS-422/485/232 data
connection
Note: To connect to a KBC decoder, a computer will be
needed to configure the encoder to MPEG4.
Default Settings
IP Address (Static): 192.168.1.100
GUI Access User Name: admin
GUI Access Password: admin
Encoder Type: H.264
Note: If the unit is hard reset to defaults the IP address will
change to dynamic 192.168.0.100 and the ID and
password to access the GUI will be Admin / 123456
Accessing the Encoder
If your computer is set to a static IP on the same
subnet as the encoder, its web browser interface
can be accessed using Internet Explorer (Version
6.0 or above) at
http://192.168.1.100 or via the
IP utility link (tool available on the KBC website,
see downloads section of this quick start guide).
Note: Microsoft Internet Explorer v6.0 and above is the
only web browser supported
Quick Start Guide
ENC-H-W* H.264 Encoder
QSG-Encoder_H264-Rev1206E www.kbcnetworks.com
Copyright © KBC Networks Ltd. 2012
Solid black wire (no white stripe) to GND terminal
Wire with white stripe to 12V terminal