NeoPro Vandenberg - Manual (Page 12)

12
Switching Protocol
Switching commands use this structure:
[VV,ii,oo]
ii is the one or two digit source input number. If this number is 0, then the
selected output will be disabled.
oo is the one or two digit output number. If the number is 0, then the selected
input is routed to all outputs.
Serial Control Examples
Here are a few examples of serial control code:
[VV,1,2]
Routes video input 1 to output 2
[VA,17,8]
Route Toslink digital audio input 17 to HDMI output 8
{[VV,1,0][VA,3,6][VX,5,8]}
Group command that first routes video input 1 to all, then routes HDMI audio
input 3 to HDMI output 6, then routes input 5 (both video + audio) to HDMI
output 8.
Setup Protocol
Setup commands have 3 parameters:
[S,x,n]
S invokes the Setup function
The table below lists values for x and n:
x n Setup function
L 0 Led OFF
L 1 Led ON
R 0 IR OFF
R 1 IR ON
V 0 Verbosity OFF
V 1 Verbosity ON
D 25 Display Brightness 25%