NeoPro Vandenberg - Manual (Page 13)

DOC42-00041-A_Vandenberg_Integrators_Guide.doc
13
x n Setup function
D 50 Display Brightness 50%
D 75 Display Brightness 75%
D 100 Display Brightness 100%
A 0 On Power Up – STANDBY
A 1 On Power Up – ON
MODE 1 Audio mode 1 – SPDIF routing
MODE 2 Audio mode 2 – 7.1 routing
DHCP 0 Auto assign IP address OFF
DHCP 1 Auto assign IP address ON
IP xx.xx.xx.xx Manually assign IP address
GW xx.xx.xx.xx Manually assign gateway address
NM xx.xx.xx.xx Manually assign netmask
Power Control
The power ON command is:
[P,1]
The power OFF command is:
[P,0]
Query Commands
x is the first letter of model name. Responses are in { } brackets.
Command Result
[?V]
Firmware version
[?P]
Power status
[?S]
Setup values
[?VX]
Switching matrix state. Responses can be re-
used as input back to the matrix switch.
•