NEXCOM NISE 2400 User Manual
NEXCOM Hardware
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Preface
- Copyright
- Disclaimer
- Acknowledgements
- Regulatory Compliance Statements
- Declaration of Conformity
- RoHS Compliance
- Warranty and RMA
- Safety Information
- Installation Recommendations
- Safety Precautions
- Technical Support and Assistance
- Conventions Used in this Manual
- Global Service Contact Information
- Package Contents
- Ordering Information
- Chapter 1: Product Introduction
- Chapter 2: Jumpers and Connectors
- Before You Begin
- Precautions
- Jumper Settings
- Locations of the Jumpers and Connectors for NISB 2400
- Jumpers
- Connector Pin Definitions
- External I/O Interfaces - Front Panel
- External I/O Interfaces - Rear Panel
- Internal Connectors
- BIOS Pin Header
- SATA Connector
- SATA Power Connector
- Port 80 Connector
- GPS Connector
- CPU Fan Connector
- RTC Pin Header
- LAN1 LED Signal Pin Header
- LAN2 LED Signal Pin Header
- 3G Line-out Pin Header
- 3G Mic-in Pin Header
- Line-in Pin Header
- Speaker-out Pin Header
- PS2 Keyboard/Mouse Pin Header
- GPIO Pin Header
- MCU Flash Pin Header
- Reset Button Pin Header
- PWR_LED/HDD_LED/SMB_BUS/S3/SW_ON/RESET
- 12VSB DC-IN
- Mini-PCIe Connector (3G, Wi-Fi)
- Mini-PCIe Connector (mSATA, Wi-Fi)
- PCIe x4 Slot (Only support PCIe x1 speed & signal)
- Chapter 3: System Setup
- Removing the Bottom Cover
- Removing the Top Cover
- Installing a Mini-PCIe Module (Half-size)
- Installing a Mini-PCIe Module (Full-size)
- Installing a SO-DIMM Memory Module
- Installing a SIM Card
- Installing an Antenna
- Installing a SATA Hard Drive for NISE 2400
- Installing a SATA Hard Drive for NISE 2410 and NISE 2420
- Chapter 4: BIOS Setup
- Appendix A: Power Consumption
- Appendix B: GPI/O Programming Guide
- Appendix C: Led Programming Guide
- Appendix D: Watchdog Timer Setting