NEXCOM NEX 980 - Manual (Page 19)

Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved. 8 NEX 980 User Manual
Chapter 2 : Installation
C
haPter
2 : I
nstallatIon
This is an ATX form factor (12.0” x 9.6”, 30.5 x 24.4 cm) motherboard.
Before you install the motherboard, study the configuration of your chassis
to ensure that the motherboard fits into it.
Make sure to unplug the power cord before installing or
removing the motherboard. Failure to do so may cause physical
injuries to you and damages to motherboard components.
2.2 Pre-installation Precautions
Take note of the following precautions before you install motherboard
components or change any motherboard settings.
▪ Unplug the power cord from the wall socket before touching any
components.
▪ To avoid damaging the motherboard’s components due to static electricity,
NEVER place your motherboard directly on the carpet or the like. Also
2.1 Screw Holes
Place screws into the holes to secure the motherboard to the chassis.
Do not over-tighten the screws! Doing so may damage the
motherboard.
remember to use a grounded wrist strap or touch a safety grounded
object before you handle the components.
▪ Hold components by the edges and do not touch the ICs.
▪ Whenever you uninstall any component, place it on a grounded antistatic
pad or in the bag that comes with the component.
Before you install or remove any component, ensure that the
power is switched off or the power cord is detached from the
power supply. Failure to do so may cause severe damage to the
motherboard, peripherals, and/or components.