Installing a wwan module – NEXCOM VTC 100 User Manual
Page 37
Advertising

Copyright © 2013 NEXCOM International Co., Ltd. All rights reserved
24
VTC 100 User Manual
Chapter 3: System Setup
Mini PCI-E slot for WWAN module
installation
1. The Mini PCI Express slot shown below is used to install a WWAN
communication module such as GPRS, UMTS or HSDPA.
Installing a WWAN Module
2. Insert the module into the Mini PCI Express slot at a 45 degrees angle
until the gold-plated connector on the edge of the module completely
disappears inside the slot.
3. Push the module down then secure it with mounting screws.
4. Attach one end of the RF cable onto the module.
5. Mount the other end of the cable to the antenna mounting hole
located at the front panel of the chassis.
Advertising