NEXCOM DNA 125B - Manual (Page 47)

Copyright © 2014 NEXCOM International Co., Ltd. All Rights Reserved. 33 DNA 125B User Manual
Chapter 4: BIOS Setup
IDE Configuration
This section is used to configure the SATA drives.
Advanced
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable SATA Device IDE Configuration
Serial-ATA (SATA)
SATA Test Mode
SATA Speed Support
SATA Mode
Serial-ATA Port 0
Serial-ATA Port 1
SATA Port0
Not Present
SATA Port1
Not Present
[Enabled]
[Disabled]
[Gen2]
[AHCI Mode]
[Enabled]
[Enabled]
Serial-ATA (SATA)
Enables or disables SATA device.
SATA Test Mode
Enables or disables SATA test mode.
SATA Speed Support
Configures the SATA controller to Gen1 or Gen2 speed.
SATA Mode
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial-ATA Port 0 and Serial-ATA Port 1
Enables or disables SATA port 0 and SATA port 1.