One Systems Pole Mount Mini - Manual (Page 8)

use one size smaller diameter on the crimping tool. For 1/16” sleeves and
cable you MUST use a 3/64” crimp set.
The cable assembly requires the use of a compression tool to securely fit the
oval sleeves. One Systems does not supply this compression tool. The assembly
of the cable must be done by one who is experienced and competent in wire rope
assembly and is familiar with the operation of the required tools.
See Figures 4 and 5 for details of the proper cable assembly to the enclosure
and bracket.
Figure 4 shows both the 103IM and 106IM loudspeakers mounted to the Pole
Mount Mini bracket with the cable assemblies included. The length of the wire
rope should be adjusted so that there is very mild tension on the cable assembly.
The cable assembly should not be loose or have any slack but the cable
assembly should not be so tight as to begin pulling the top of the enclosure back
toward vertical. The length of the wire rope is determined by the tilt and pan
angles of the enclosure.
Figure 4