One Systems U Bracket - Manual (Page 2)

2
WARNING: Do not substitute the specific “U” bracket. Do not use the specific “U” bracket on any enclosure
except for the enclosure specified. Do not suspend the enclosure with any “U” bracket except for the specified
“U” bracket.
WARNING: All associated rigging is the responsibility of others.
INSTALLATION INSTRUCTIONS
112IM and 212CIM
1. See the product view below.
2. Remove the two M10 plastic covers from the positions as shown.
3. Attach the rubber washers (1 each) over each mounting hole. One each side as shown.
4. Mount the 112IM-U U-Bracket to the wall or ceiling surface. Insure that the bracket is properly and
securely mounted. The mounting surface MUST be capable of supporting the necessary weight to
achieve a safe working load. This must be done by a professional rigger or structural engineer familiar
with all local and national codes.
WARNING: Do not hang or otherwise suspend any other objects from the loudspeaker and U-Bracket
assembly!
5. Position the enclosure between the U-Bracket ends. Install the two M10 bolts, flat washer and lock
washers, one set on each side. This operation should be performed by at least two people. Once the
enclosure is safely mounted, adjust to the desired angle and tighten the M10 bolts.
6. A secondary safety cable (not supplied) is always recommended.
212IM and 312CIM
1. See product view below (Figure 1)