One Systems U Bracket - Manual (Page 6)

6
The image above shows the top of the 108CIM. Use this location for the U bracket.
The image above shows the bottom of the 108CIM. Use this location only for the U-Bracket!
2. Place the rubber washers over the top and bottom U-Bracket mounting holes
3. Mount the 108CIM-U U-Bracket to the wall or ceiling surface. Insure that the bracket is properly and
securely mounted. The mounting surface MUST be capable of supporting the necessary weight to
achieve a safe working load. This must be done by a professional rigger or structural engineer familiar
with all local and national codes.
WARNING: Do not hang or otherwise suspend any other objects from the loudspeaker and U-Bracket
assembly!
4. Position the 108CIM between the U-Bracket ends. Install the two M8 bolts, flat washers and lock
washers, one set on each side. This operation should be performed by at least two people. Once the
enclosure is safely mounted, adjust to the desired angle and tighten the M8 bolts.
5. A secondary safety cable (not supplied) is always recommended.
103IM/106CIM
1. Remove the U-Bracket from the enclosure.
2. Mount the 103 or 106 U-Bracket to the wall or ceiling surface. Insure that the bracket is properly
and securely mounted. The mounting surface MUST be capable of supporting the necessary
weight to achieve a safe working load. This must be done by a professional rigger or structural engineer
that is familiar with all local and national codes.
3. Place the rubber washers over the top and bottom of the enclosure if they have come off.
4. Position the 103IM or 106IM between the U-Bracket ends. Install the two bolts, flat
washers and lock washers, one set on each side. Once the enclosure is safely mounted, adjust to
the desired angle and tighten the bolts.