Paxton Superchargers Mustang Renegade Class - Manual (Page 7)

P/N: 4809622a
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
07SEP06 v2.0 MusRenegade(4809622a v2.0)
2-1
2.1 INSTALL THE S/C MOUNTING
PLATE
2.2 PLASTIC IDLER INSTALLATION
A. Attach the supercharger mounting plate,
(item #2) to the back plate using the 7-1/2" long
7/16" bolt (item #31). DO NOT fully tighten.
DO NOT install the bolts and spacers that go
into the water pump at this time. (items #40,
#41.)
B. Slide the three 7/16" bolt with washers (item
#32, #35) through the front supercharger sup-
port plate. Slide the spacers onto the bolts, and
loosely attach the bolts to the other brackets.
C. Slide the support arm (item #7) between the
two plates until the single hole at the end of the
support arm lines up with the hole at the center
of the triangular bracket. (Item #8.)
*** NOTE ***
There are two sets of holes in the support arm. This
is to accommodate the diffeent deck heights on the
302 and 351 engines. Secure the support arm using
the two 3/8" bolts ( item # 22). DO NOT fully tighten.
DO NOT install the spacer ( item # 11) at this time.
Section 2
MOUNTING PLATE INSTALLATION
C. Go back and tighten all loose bolts. Check the
fit of the remaining spacers (items #11, #40,
#41). They should fit snugly into place. Due to
the factory tolerance, after market heads, water
punps, gasket thicknesses, etc., these spacers
may need to be shortened slightly. Failure to
assure a proper fit for these spacers, either leav-
ing them too long or too short, will cause the
bracket to sit crooked and may cause a thrown
belt. Measure as accurately as possible.
*** NOTE ***
The 351 based engines will use only one bolt and
spacer into the water pump.
D. Install the idler pulleys (item #17, #19), the
supercharger bolts (item #21) and spacers
(item #4).
1.
Attach the oil drain (not provided in this
kit) to the supercharger.
2. Attach the oil supply hose (Appendix “F”)
to the NOVI 2000.
3. Install the NOVI 2000 Race Supercharger.
4. Connect the oil supply hose to an oil sup-
ply. This can be located at the oil sender
unit.
A. Install the plastic accessory idler using the
8-3/4" long bolt and washer (items #29, #30)
and the step collar (item #18). DO NOT fully
tighten.
B. Slide the spacer (item #10) between the two
plates so it lines up with the hole that is the sec-
ond from the bottom, as shown in Appendix
“B”. Slide the bolt (item #36) through both
plates and spacer to hold it in place.
*** NOTE ***
If you are using a pulley combinaztion other than
those supplied by Paxton, you may have to re-posi-
tion this spacer either up or down, depending on the
pulley diameter. DO NOT install the pulley at tlhis
time.