Paxton Superchargers Dodge Viper - Manual (Page 19)

6-1
P/N: 4809643
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v1.1 01-03Viper(4809643v1.1)
Section 6
SUPERCHARGER MOUNTING BRACKET INSTALLATION
6. SUPERCHARGER MOUNTING BRACKET INSTALLATION
A. Install the supplied mounting bracket onto
the head using the factory power steering
bracket screws.(See Fig. 6-a.)
***NOTE***
Mounting bracket/spacer to shock tower support clear-
ance may be too small on some vehicles. Lightly sand
one or both parts until 3/16" clearance is achieved.
B. Install the power steering pump in the facto-
ry manner onto the mounting bracket just
installed using the factory pump bolts. (See
Fig. 6-b.)
C. Install the supplied -6 x 18mm adapter into
the high pressure port on the power steering
rack. Install the supplied -6 x 16mm adapter
into the pump, attach the supplied power
steering hose to the pump so that it is routed
towards the passenger’s side. (See Fig. 6-b.)
Route the free end of the hose around the
mounting bracket, under the AC compressor
and attach to the power steering rack.
D. Replace the hose running from the power
steering cooler to the reservoir return fitting
with the supplied 11/32" hose.
E. Secure the power steering lines away from
contact with sharp or moving objects using
the supplied zip-ties.
F. Re-install the accessory drive belt.
Fig. 6-a
Fig. 6-b