Tview D76TSB - Manual (Page 4)

Bend as many claws outward for tight fit,
to lock the sleeve into place.
Install the trim bezel to the unit.
(Arched surface toward the bottom).
Use the Rear Mounting Bolt to support the unit.
UNIT INSTALLATION
Installation Method 1: Din Front-Mount
Install the Mounting sleeve into the dashboard.
Installation Method 2:
Using the screw holes at the sides of the unit(ISO Mount).
1. Remove the hooks on both sides.
2. Select a position where the screw holes of the mounting bracket supplied with the
car and the screw holes of the main unit become aligned, tighten the screws on each
side, and re-mount the brackets with the factory hardware in the original location.
NOTE:
1 and 10 are not used for installation method2.
Tighten the screws
to your car
UNIT REMOVAL(when installed using the sleeve)
1. Detach the trim bezel.
2. Insert the keys supplied with the unit on both sides(as illustrated) as this will
release the internal locks so you can slide the unit out.
3 4