Zektor SoloCAT™ CAT5 Extenders - Manual (Page 2)

2
1. Specifications
2. Introduction
Overview
Thank you for purchasing a premium quality Zektor SoloCAT
™ product. Our CAT5 Video System
SoloCAT series extends component video with stereo analog or digital audio signals over commonly
available Category 5 cable. Through enhanced engineering, Zektor is able to accomplish audio, video
and power transmission over a SINGLE CAT5/5e/6 cable whereas most manufacturers require two
cables to do the same transmission with lesser results. Analog or digital audio can be supplied at the
transmitter side, analog and digital audio will be available, simultaneously, on the receiver side.
Note: The receiver analog outputs will only output digital audio if it is PCM stereo digital audio. If Dolby,
or DTS digital audio is received, it will only be available on the digital output of the receiver, the analog
outputs will be muted.
This user manual covers the Zektor SoloCAT
™ CAT5 Audio Video CATX Transmission Products.
Included items
• SoloCAT™ Transmitter (if ordered as a pair with a SoloCAT™ receiver)
• SoloCAT™ Receiver (wall plate or flush mount)
• 100-220VAC 50-60Hz – 12VDC Power Adapter (good for up to 500’)
• SoloCAT™ Manual
• Optional additional Power Adapter (required for runs from 500’ to 1,000’)
Cable CAT5/5e/6
Video resolutions 1080p / 1920X1200 (WUXGA)
Video enhancement Optimized gain control and
equalization
VGA version Local DDC pass through
Transmission distance
500’ powered one side*
1000’ powered both sides*
Audio Analog stereo / SPDIF
Audio Connections RCA or 3.5mm jack
Video Connections BNC / RCA / VGA
Power 15V DC <1 Amp
Operating temperature 32 to 131 deg F (0 to 55C)
Connectors RCA (Component & SPDIF)
RJ45F
Enclosure Metal, RF shielded
Dimensions
7” X 4” x 1.5”
Weight <1 lb
Warranty 2 years
*The SoloCAT™ wall plate version will support audio,
video and power up to 1000’ when transmitted from a
Zektor Prowler CAT5 matrix switch. If the wall plate is
used with a SoloCAT™ stand alone transmitter, a
maximum of 500’ is supported. In addition, power will
need to be applied at the transmitter side only.