Zektor SoloCAT™ CAT5 Extenders - Manual (Page 6)

6
Problem: Poor audio quality or no audio at all
Solution:
Powered speakers are required. Make sure speaker power is ON.
Check input source levels from the source device.
Make sure the audio source is not overdriven or underdriven. Verify that you are using the correct
type of audio cable.
Check cable routing to avoid close contact with electrical cable, lights, electrical junction boxes
and/or electrical panels which can cause EMI/RFI interference with certain cable manufacturers.
Problem: Connected to another manufacturer product
and it won’t work at all
Solution : Buy a complete Zektor SoloCAT™ solution
NEVER use a Zektor SoloCAT™ transmitter or receiver with another manufacturer’s product.
Safety
This unit has no user serviceable components. Do not remove the cover of this unit under
any circumstances. If the unit becomes defective, please call Zektor Incorporated at 858-
748-8250 for a replacement. If the safety seal is broken the unit will not be replaced.
Emissions and Immunity
A Category 5 (or better) twisted pair cable must be used to connect the modules in order to
maintain compliance with radio frequency energy emission regulations and ensure a suitably high
level of immunity to electromagnetic disturbances. All other interface cables used with this
equipment must be shielded in order to maintain compliance with radio frequency energy
emission regulations and ensure a suitably high level of immunity to electromagnetic
disturbances.
FCC Compliance Statement (United States)
This equipment generates, uses and can radiate radio frequency energy and if not installed and
used properly, that is, in strict accordance with the
manufacturer’s instructions, may cause
interference to radio communication. It has been tested and found to comply with the limits for a
class A computing device in accordance with the specifications in Subpart J of part 15 of FCC
rules, which are designed to provide reasonable protection against such interference when the
equipment is operated in a commercial environment. Operation of this equipment in a residential
area may cause interference, in which case the user at his own expense will be required to take
whatever measures may be necessary to correct the interference. Changes or modifications not
expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de la classe A prescrites dans le règlement sur
le brouillage radioélectriques publié par le ministère des Communications du Canada.
Zektor Incorporated states that best practice engineering principles and good
manufacturing processes are utilized in all facets of the product(s) design and
manufacture. In purchasing any product(s) from Zektor incorporated or its affiliates, you
accept that Zektor Incorporated makes no warranty or representation, either express or
implied, with respect to hardware, software or documentation other than the standard
warranty including, but not limited to, their quality, performance, merchantability, or
fitness for a particular purpose. As a result, this software or documentation are licensed
"as is" and you, the licensee, are assuming the entire risk as to their quality and
performance. In no event will Zektor Inc. be liable for direct, indirect, special, incidental, or
consequential damages arising out of the use of or inability to use the hardware, software
or documentation.
Zektor Inc. and the Zektor Inc. logo are trademarks of Zektor Incorporated