Zytronic ZXY110 - Manual (Page 23)

Integration Manual - Issue 1 Zytronic Projected Capacitive ZXY100/110 ® Touch Controller & Sensor 23
USB CABLE HELD IN PLACE
Adding cable clips similar to those shown in Figure 23 will reduce the risk of damage occurring to the
controller PCB connector if the cable is accidentally pulled. If adhesive pads are used on the clips, it
must be ensured that they will maintain their adhesion at any temperature that they may be subjected
to in service.
CABLE CLIPS HOLDING CABLE IN PLACE
The LCD video and power connections should be connected to the LCD, as shown in Figure 24, and to
the PC and power sockets.
FIGURE 22
FIGURE 23