Argox PA-20 Portable Data Collectors User Manual - Manual (Page 36)

32
6.2 Bluetooth Communication
The Bluetooth interface support SPP mode (Serial port profile) can be used to connect a
Bluetooth compatible printer. Data can be transferred if the terminal is located within ten
meters of the target device (while nothing is blocking the signal).
Set up instructions
1. Press 1+3+0+power key at the same time and PA20 will enter supervisor menu.
The password default is 00000.
2. Select 5.Bluwtooth -> 1.Setup, it will enter Bluetooth setting menu like Figure 6-2
Figure 6-2
3. The menu includes basic Bluetooth setting.
(1) Device Name: name of PA20 Bluetooth device.
(2) Pin Code: set Bluetooth pin code.
(3) Security Mode: select security of Bluetooth, default is disabling.
(4) Inquiry timeout: set inquire time, default is 3
(5) Max Response: set max number of response device, default is 10.
(6) Set Peer Device: search Bluetooth device.
4. Select set Peer Device, it will appear two methods to search Bluetooth device.
(1) Set by Search: search Bluetooth device in the neighborhood.
(2) Set by Keyin: search Bluetooth device by key in Mac address.
5. After search Bluetooth device, user can use Bluetooth Test function to test
connection.
Path is 5.Bluetooth -> 2.Bluwtooth Test.
PS. Bluetooth of PA20 only support SPP mode.