Artesyn ARTM-9405 16x10GbE Installation and Use Guide (May 2014) - Manual (Page 27)

LEDs and I/O Interfaces
ARTM-9405 16x10GbE Installation and Use (6806800P45F) 27
The faceplate of the blade provides the following interfaces and control elements:
 Eight SFP+ Bays
 Two QSFP Bays
 Serial Console
 Status LEDs according to PICMG3.0
 Recessed Push Button Reset
The blade design provides the possibility to cover unused faceplate elements like LEDs or push
buttons behind a custom overlay foil.
3.3 Keying
Mechanical keying is provided according to ATCA 3.0 Base specification.
3.4 Heat Sinks
Passive heat sinks are required for Netlogic NLP10142 PHYs.
3.5 Port Pin Assignments
3.5.1 SFP+ Connector
The SFP+ connector resides inside the SFP+ cage and is only accessible via an SFP+ module.
Table 3-1 SFP+ Connector Pin Assignment
Pin Description
1 GND
2 TxFAULT
3 TxDIS