Artesyn ATCA-MF106 Installation and Use (September 2014) - Manual (Page 55)

Chapter 4
ATCA-MF106 Installation and Use (6806800M62B) 55
Board Exchange
4.1 Introduction
This chapter describes how to install the ATCA-MF106 board and includes the following
information:
 Before installation
 Installing the board in a shelf
 Starting up the board
 Removing the board
 Operation
4.2 Before Installation
This section provides the following information:
 Requirements
 Unpacking and inspecting the board
4.2.1 Requirements
Before you power up the board, calculate the power needed according to your system
configuration.
The system is shipped with pre-installed ATCA-MF106 boards. You have to observe the
following procedures when ordering a board as a spare part or exchanging a board.
For more information on installing and replacing the ATCA-MF106 board and for a
description of replacement scenarios, see the Centellis 2000 Shelf-DC Installation and Use
manual.