5 installing accessories, Installing accessories, Hardware preparation and installation – Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) User Manual
Page 39
Hardware Preparation and Installation
MVME7100ET Single Board Computer Installation and Use (6806800K87E)
39
If you are installing the optional MVME7216E transition module, refer to
for configuration switch settings.
2.5
Installing Accessories
This section describes the procedures for installing the MVME721ET transition module, PMCs,
and the XMCspan on the baseboard.
S2-6
GA2
1
S2-7
GA1
1
S2-8
GA0
1
1. The VME SCON MAN switch is OFF to select Auto-SCON mode. The switch is ON to select manual SCON mode which
works in conjunction with the VME SCON SEL switch.
2. The VME SCON SEL switch is OFF to select non-SCON mode. The switch is ON to select always SCON mode. This
switch is only effective when the VME SCON MAN switch is ON.
Table 2-6 VME System Controller and GA Switch Settings (continued)
Position
Function
Default