Avalon Firestyles 864 Winthrop Bungalow - Manual (Page 3)

Winthrop (864) Bungalow, Tree of Life
99300487 Bungalow 95800386 Tree of Life
Page 3 of 7 10/16/07 © Travis Industries, Inc.
Installation
1 Remove the glass frame from the fireplace (see the owner's manual for details).
2 Install the hinge brackets onto the fireplace following the directions below.
Remove and discard the nuts and bushings attached to the stud
plates near the firebox (HINT: To prevent the stud plates from
falling out, we recommend removing one nut and bushing and
installing a nut before removing the second nut and bushing.).
1/8”
Slide the hinge brackets into place
- the slots on the bracket slide over
the press studs on the fireplace.
Hand-tighten these nuts
on the stud plates.
Secure the hinge
brackets to the fireplace
with the included
screws.
Repeat these steps for
the opposite side.
NOTE: The hinge brackets have a notch
on the bottom - this helps determine the
left bracket from the right bracket.
Discard the nuts
and bushings.
Hand tighten the upper nut. Use
a wrench to securely tighten the
lower nut to prevent the hinge
bracket from bending while the
doors are in place.
11/32" Open End Wrench
Attach the nuts included with this kit. Do not secure the nuts all the
way - leave a 1/8” gap between the nut and the stud plate.