Avalon Firestyles Driftwood Log Set B - Manual

Driftwood Log Set “B”
Installation Instructions
(sku 94500572)
Page 1 of 10 17601711 - 7/16/12 © Travis Industries, Inc.
Packing List
 Log
Set
Items Required
 ¼” Crushed Glass (see page 9 for quantities):
-- Platinum (94500580)
-- Reflective Bronze (94500581)
-- Cobalt (94500582)
Compatibility
 33
DVI
 DVL
GSR NB
 864 HO NB with Diamond-Fyre Burner

Cypress Stove
Installation Warnings
The glass must be installed in accordance with this installation manual or instruction sheet.
Failure to install the glass correctly may lead to a safety hazard and will void the warranty.
The logs must be installed before placing the glass to prevent sooting.
 The logs are fragile, especially after being exposed to heat.
 Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
 Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
 The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated
and the pilot is properly aligned. See owner’s manual for details on burner removal.
HINT: If using propane (LP), convert the appliance before installing the log set.
HINT: If using optional firebacks, first make the modifications to the burner (see below). After modifying the
burner install the firebacks then the log set.
Preparing the Burner for Log Set Installation
The log set requires the burner to be modified. Remove the two screws holding the ember trays in place (see
below). Remove the ember trays.
Newer Units
Older 33 DVI