Avalon Firestyles Fireplace Insert Wiring Kit - Manual

Wiring Kit, Gas & Pellet Inserts
97200315
Page 1 of 6 17601371 – 1/31/2014 © Travis Industries, Inc.
Compatibility
• Travis Gas Inserts
• Travis Pellet Inserts
Important Warnings
This kit must be installed in accordance with local electrical codes. Consult your local building
official for any requirements that must be met in your area.
Make sure the electrical lead leading to the insert has been disabled prior to installing this kit.
Packing List
• 8' Flexible Conduit with 90° Connector • Mounting Bracket with Backing Plate
• 10-24 Self-Tapping Screw • Pellet Insert Wiring Adaptor
Gas Insert Installation
1. Disconnect the molex connector leading from the power cord to the appliance.
616 Insert – Remove the right side access panel to access the molex connector.
Disconnect this
molex connector.
Power Cord
Control Panel (may be removed to
access molex connector).
2. Disconnect the strain relief from the appliance and remove the power cord.
Use pliers to compress the strain relief
from the top and bottom while pulling it
out of the hole in this bracket.
Remove the power cord
(it may be discarded).