Avalon Firestyles Fireplace Insert Wiring Kit - Manual (Page 2)

Wiring Kit, Gas & Pellet Inserts
97200315
Page 2 of 6 17601371 – 1/31/2014 © Travis Industries, Inc.
Gas Insert Installation (continued)
3. Route the conduit into the appliance from behind on the right side. Attach the conduit to
the side of the insert as shown below.
The strain relief is attached to the right side of the fireplace insert. Insert the
locknut over the molex connector and screw it onto the conduit connector.
4. Attach the molex connector from the conduit to the connector on the appliance.
Attach the molex connector on the conduit to the molex
connector on the insert.
NOTE
: You may need to feed the wires through the conduit
for it to reach the wiring harness on the insert. If needed, you
can cut the conduit jacket to allow for proper wire access.